Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to implement Ipv6 on my network. From the FTD I can ping all zones and ping all vlans behind the zone. I cannot ping from endpoint to endpoint across the zone. I do not see any blocks or allows in the event list. What an I missing?? James
I want to factory reset a 3850. I want to find out if there is a way to reset all variables to default. "wr er" , delete nvram: startup-config and hold mode button down does not reset everything. For instance the switch priority will not change to pr...
We had some Nortel switches. When the client was turned off the link on the switch was off. We liked it because it showed when systems were active and in use. Now we switched to some 3850's and the link stays active all the time no matter what the st...
So, when you get a switch new in the box it boots up as priority 1 and the switch is not stacked so it is switch 1. I want to take a switch out of a stack and I want to reset the whole configuration. I know I can delete the startup and Vlan.dat files...
