Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
as we know, in cisco catalyst 3750x, we can limit the bandwidth gig interface with the speed command, whereas in tengig interface that option is not there. My question, how can I limit the ingress and egress bandwidth of the Tengig int...
Hi everone,
what is the difference between Anycast RP and MSDP? Does MSDP requires point-to-point connection to the peer? and Anycast RP does not require?
Thanks
Hi everyone,
I have attached a topology design for IP Multicasting, Spine- Leaf network. I would like to know what is the best IP Multicasting redundancy implementation for such topology.
Thanks alot
Hello everyone,
I have a problem receiveing a multicast stream on a same vlan. My toplolgy - attached too - is as following:
SW1: configured with one vlan (vlan 80) and two hosts (host for multicast stream and the other for receiving, Rcvr -01.
S...
Hi Harold,Thanks a lot for the Information. As I understand, Anycast RP- MSDP is load sharing and RP hot backup, my Question is how can I make the RP redunancy determnistic, that means let's say I have two L3 switches ( core switches/Spine) as in the...
Hi Harold,Thanks for the document. Now, it is a little bit more clearer. But, I still have some questions:1) do I still need point-to-point connection between the peers?2) what is the difference between ip pim rp-candidate x.x.x.x and ip msdp origina...
Hi George, Hi Paul,
Thanks for the information and the links. I am currently going through these links and I will post what I understand soon.
how do I relocate this topic to the Data Center? is it a feaure or I should copy-paste?
Thanks
