Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After approximatly 24 hours of operation on a VPN between a RV120W and an ASA5520 the RV120W fails to respond to the XAuth requests. I was able to capture the following logs in the RV:2011-04-01 07:08:02: [router20AAB6] [IKE] INFO: Received attribut...
When CUCM is using LDAP for authentication several subsystems including CTI manager utilize this mechanism for device authentication. One for example is the CTI manager the invokes an LDAP authentication process with LDAP when a CUPC user enabled des...
In looking at the deployment guide for CUPS7 there are several deployment models for balancing users within subclusters and references to the use of SRV records to facilitate seemless failover between failed nodes for subscribe and message requests. ...
Hi Scott,I was able to get the RV120W to succesfully act as an EZVPN Client with Network Extension Mode to an ASA... I cant imagine it would be very different on a IOS router acting as a server.. Heres what I did.One the IKE PolicySet mode to initiat...
Hi Michael,Thanks for the reply. I do know now that the timestamp is a unix epoch timestamp for sometime in 2033.. but this is the only delta in between a successfull result and a failure.. I am requesting logs from the LDAP side of the house to see ...
Hi Mike,Thanks for the reply.. Based on the deployment guide the SubCluster SRV is then merely a mechanism for inter-subcluster communiction resilliency and or publish resilliency for CUCM<->CUPSJP
One item you may want to try is to configure a voice-class codec and set the first preferred codec to 729r8 with the second being G711U, then apply the voice class codec to the indbound voip dial-peer vs setting a single codec for the dial-peer.
In regards to SW2 and its amber port LED.. Here are a few things to check. 1. Verify VLAN60 exists in the VLAN databse. "sh vlan" should show VLAN60 in the table.2. Verify there is no spanning-tree bpdu-guard on the uplink port. 3. Check your crossov...
