Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello colleagues,is there somebody please with an experience with fTriage (end-to-end ELAM automation tool) in ACI Multi-Site environment? According to the available (although limited) information and examples in the command help, multi-site should b...
This exact bug seen in version 2.2(3i) as well. Newly created Physical Domain was not visible in MSC at site-level template configuration. Logging out and in again helped to resolve the issue.
Hello all,we, as a student company act as an ISP for university dormitories. We would like to (if it's possible) deploy QoS to prefer multicast traffic over all other types of traffic. Devices used in network:Acces layer: Cisco Catalyst 2950, 12.1(2...
Hello there,According to documentation for this switch it can be configured only via web interface. I'm not sure if it wont be too limiting for this scenario. However, the thing is when you want to use several VLANs, you will need a routing between t...
Hi Rajkumar127.0.0.0/8 is simply defined as loopback network by RCF 3330. For more detailed infomations, you can read that document . Basically you can try to ping any IP address, not just 127.0.0.1 and it will work as loopback, they are all mapped o...
Hello Srini,as far as i know, there are 2 types of load balancing. In general, load balance occurs when there are multiple paths with the same metrics to the specific network in the routing table from the same routing protocol. You can configure per-...
Hi Shane,I dont exactly know how to solve your problem, just wondering - if SW1 is root and is directly connected to SW4, you should expect Gi0/1 on SW1 to be designated - FWD state, but at SW4 Gi0/1 will be root port, so in FWD state too (not blocke...
