Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Team,When I configure CUCMBE-WRKSP-BDL in NetFormx (or in the online Configuration Tool), it offers me the following for the 1 year UCSS part number (customer is gov't): UCSS-CMBE-WL1.However, when our internal folks go to order the quoted configura...
When I perform a "show ip igmp groups" on my Catalyst 4507, I see the following:Cat4507R_Lab_Admn#sh ip igmp groupsIGMP Connected Group MembershipGroup Address Interface Uptime Expires Last Reporter224.0.1.40 Vlan101 ...
Is it possible to trunk VLAN's over the the IPS module on the ASA so that traffic OTHER than the traffic normally passing through the ASA (from inside interface to outside interface) can be monitored?In this scenario, the ASA is being used as a VPN c...
Read the PDF doc called:Designing a Campus Network for High Availability.http://www.cisco.com/application/pdf/en/us/guest/netsol/ns432/c649/cdccont_0900aecd801a8a2d.pdfIt essentially recommends that dual supervisors only be used in SPOF points - not ...
I understand how to configure the Catalyst 6500 switch so that the monitoring ports are access ports in two separate VLAN's for inline operation. However, I don't see any documentation that describes how the desired VLAN traffic gets forced through ...
Thanks. They should explain that in the documentation!So, the new VLAN-on-a-stick method (Inline VLAN Pair) in 5.1 is essentially the same as the the current method (Inline Interface) except that it scales by creating each pair on a subinterface?What...
Marco,How does this apply to failover for IDSM's? i.e. what is the recommended method of providing high availability for an IDSM deployment (inline IPS)1) Where you have two IDSM's in a single Catalyst 6500?2) Where you have on IDSM in one of the ...
Marco,As always, thank you for the response. I think I catch most of that. However, in an existing network, where we have IDSM's in core 6500's at multiple sites, and have about 60 VLAN's, how do I determine which VLAN's go through the IPSM?In my s...
