Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am position to migrate from CatOS 6509 switch to native IOS 6509 switch. long time ago, there was some site to convert automatically based on copy and paste onto the tool, but i can not find. Does anybody know how to convert CatOS configuration to ...
Hi, allI am facing with a little curious question in terms of COS on untagged port.My question is that how COS field can be marked in untagged port if i command "switchport port extend cos 1"generally we can control COS field in accordance with tagge...
Hi, all. I am struggling that if SUP engine can be configured as a active with manual configuration. If I equipped two engines, SUP automatically decide to elect a active module. But I want to know which slot is higher between two slots. And how can ...
Hi, all.I am struggling that if SUP engine can be configured as a active with manual configuration.If I equipped two engines, SUP automatically decide to elect a active module. But I want to know which slot is higher between two slots.And how can i c...
Hi Karthik,I just followed SCCP configuration, however i can not dial out between VG224 and SRST IP phone.do i need to have dial-peer no SCCP ?I could see VG224 successfully registerted to SRST VGW by command show ephone registration.HQ-Tokyo#sh eph...
Thanks a lot, marwanshawi,I meant COS field. If you mark COS 5 for voice,and COS 2 for Data, how does switch fill cos 2 in untagged packet ?It makes sense Voice packet, because Voice will be tagged with VLAN ID. but For data traffice,PC, there is no ...
