Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
One question that I haven't found a direct answer to;
I currently have a base license on a 5520.
I'd like to buy & add a 25 unique user SSL license.
Once a single license is used is it gone from the pool for good? Say an employee leaves or a ...
Hello,I have a Cisco Wireless Lan Controller connected to gig 1 and from the WLC I'm unable to ping vlan4, I can ping every other vlan except for this one. Do I just need to add vlan 4 to the port channel1?Any help would be great and I can provide an...
Hi,I've just obtained an ASA 5510 and everything was working fine as far as writing to memory as I was configuring it. Now when I go to save any changes at all I get Error - Invalid Input Detected.Not sure if it's related, but when I go to "Tools- Fi...
Thanks guy's.Our prior admin set this switch up so not sure as I only know some basic configuration at this point.Also Jon, when I run that command I get;AELIB_SW178#sh int trunk gi0/1 ^% Invalid input detected at '^' marker.T...
Thanks Jon,So I would just add it under the Portchannel1 instead of gig1...correct?Wireless is working fine to the multiple ssid vlans.We run ip phones and just picked up a couple 3631 wireless ip handsets and am trying to get them to communicate to ...
Thanks,Now after upgrading via tftp and putting asdm 602 in disk0, when I run asdm launcher I get an error stating that it's unable to launch because I do not have the appropriate device manager installed. Asdm launcher supports asdm5.0 or higher ver...
Hi & thanks,I completed all these steps including reformatting drive0:Then I ftp'd the asdm file back over.I can see the files on drive0: fine through the CLI, but in asdm 5.0 under "File management" it's still not showing any files just invalid mark...
