Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Pro.I need some clarification about Bridge, Route & Gateway as a Hardware Secondly what is the meaning by bridging the vlans and routing the vlans.ThanksBhargav
Hi all,I have hub and spoke environment that is connected via point to point link. For back we have ISDN PRI line at Hub side and ISDN BRI line at spoke side. When ever a site lose P2P connection it automatically connect via ISDN. Now the issue is th...
In HSRP we are facing some issue in implementation. As for the network brief, Network Diagram and configuration of both the Cisco 3560 switch is attached here. There are two Cisco 500 switches at the edge, in these switches we have just given Managem...
Hi,I have 2800 series route at central location with PRI line and remote location with BRI line and DLINK router. i have 10 remote site.Now i want to connect my multiple remote site through BRI to my PRI at central locationcan you guide me with the c...
Dear all i have 3750 which does interVLAN routing and a default route for internet with DHCP enable now what should be good for redundancy purpose HSRP or VTP&STPone more thing in VTP does the VTP update the IP address in the VLAN to the clienti have...
As Jon said you are not require to connect routers directly on your LAN segment.And for the Wan failover you need to track Wan interface under HSRPBhargav
yesas earlier you have put specific route then you have to put the default route and after putting the default route you can remove the specific route as both are pointing towards the same 10.20.25.65H2HBhargav
Hi,sorry to be late to answer ur question.yes you need to put specific route at ROUTER and at FIREWALLas both the devices are unaware of each other's network.Switch is aware of both network. so no need to put route in the switch.H2HBhargav (rate if u...
HI,From the diagram i see that you have link between your FW and SW with ip address 10.20.25.61 and 10.20.25.62 You have your VLAN configured with 10.20.25.65 255.255.255.248so which means you have two differen subnetso i thing you required route in ...
It may be because your Secondary switch restart and last time you have not saved your configurationOr somebody mess up with the configrationCheck with Show VersionH2HBhargav
