Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am no expert in CISCO ASA configuration and I am looking for help on an issue that has come my way
VDSL Router in bridged mode - ASA gets its IP and default route through PPPOE (no issues)
Site to Site VPN between HQ and Branch office (no is...
Hi Everyone,I am having trouble with packet tracer 5, I cant create sun-interfaces on serial linksI can do it on Ethernet links no probs just the serial..Is it supported??int ser 0/0encapsulation frame relay ietfframe relay lmi-type ansino ip address...
Hi Guys and Girls, I am sitting here in the early hours of the night in Ireland trying to figure out if it possible to complete my simulator network. this is the low down1 network lots of clients; but all in different VLANs. I have clients in VLAN 12...
Hello guys, is there anyone in here that can help me with an issue that i am having trying to set up my new 837 router to Eircom ISP. I have got the settings but it does not work for me, is there anyone that can help with this problem?? please
int ser 0/0encapsulation frame relayno ip addressno shutexitint ser 0/0.120 point-to-point%cannot create Frame Relay sub-interface anybody have any idea what is going on or does packet tracer 5 not support sub-interfaces on serial links
What you need to do here is create an Access Control List on the router. you will need to read up on ACLs because there is a bit to learn, An access control list can filter traffic (any or all traffic)coming into or leaving your network. this shou...
This is my update...4 VLAN's 4 reg switches 1 L3 switch 1 routerEach VLAN in different subnets all 50.x.x.x rangeInter- VLAN routing works fineI want a DHCP pool that will assign IP addresses to all subnets; I know I will need more than 1 pool for th...
ok Hi first of all,Router A connected to 10.x.x.x & 175.x.x.xRIP command should be router rip ver 2net 10.x.x.xnet 175.x.x.x not sure of the subnet router rip version 2 network 10.x.x.x network 192.168.2.0dont forget to config your bandwidth on the...
Thanks for the prompt reply,Its a pppoe on a dsl line this is the sheet from the ISP:is there something missing??Current configuration : 1414 bytes!version 12.2no service padservice timestamps debug uptimeservice timestamps log uptimeservice password...
