Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to configure 2 L2 ports on Catalyst C1000 with Primary/Standby functionality. These ports connected to 2 ISP with L2 links.Primary port should be up and standby should be down until primary port will be down.On 2960 switches we used flexlink f...
After Catalyst C9500-24Y4C Switch upgrade from Gibraltar-16.12.4 to Bengaluru-17.6.3 this ETA commands don't available in configuration:et-analyticsip flow-export destination X.X.X.X 2055vlan configuration XXXip flow monitor IPv4_NETFLOW inputet-anal...
I have FTD managed by FMC. How can I configure FTD interface to get IP address from DHCP server? There is only static ip option available in interface ipv4 settings. Thanks.
Yes, ports to both providers are trunks and allowed vlan the same on both links. But its a different outside networks and primary link has much better capabilities. So we need to up backup link only when primary is down.
Both providers are different with no-cisco equipment. I can use only port status on my C1000 switch. Maybe it possible to use tcl script for it but I have not expirience with it and couldn't find if it is supported on C1000.
Hello!I think this topic - Creating a Service Account in Windows Active Directory for Kerberos Authentication in High Availability Deployments https://www.cisco.com/c/en/us/td/docs/security/wsa/wsa_14-0/User-Guide/b_WSA_UserGuide_14_0/b_WSA_UserGuide...
