Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts,So i begin to study isis but i stuck and need your help. This is my topology : In shorts, on R4 and R1, they are not receiveng 192.168.1.12/32 prefix form R3. But in R2, it is receiving 192.168.1.12/32 from R3. I'm sory for the very bas...
Hello Experts!So i have a problem that the server has tcp reset flag. My customer want to know is there any way that the cisco ASA reset the tcp connection? In my understanding that the asa will reset the connection when the tcp session is idle for 1...
Hello Experts!My customer have ASR1002 IOS-XE 15.1.(3).So they want to make Gi1/0/1 and Gi1/0/2 as 1 port channel (Po1). From that Po1, they want to make 2 subinterface po1.300, po1.305. Po1.300 as GW for VLAN300 and Po1.305 as GW for VLAN305. This ...
Hello experts, So i have an L3 switch (3850) and N7K. They are connected by a single link 1 gig. Gi1/0/1 in 3850 and eth3/3 in N7K. That one link is to connect ospf. On 3850 side, Gi1/0/1 is a trunk, and the ospf in 3850 is on its interface vlan. On ...
Hello experts, Please your insight and enlighment about etherchannel load balance.To be quick, what is default load balance method for layer 2 etherchannel? what is default load balance method for layer 3 etherchannel?Can layer 3 etherchannel using m...
Hello sir, Thank you very very much for your crystal clear explanation, i'm labbing from your advice and yes L2 roututes can be distributed to L1 via route-map. May i ask one more question sir? By default L1 has default route to L1/L2 routers in its ...
Hello sir thx for the enlighment, Unfortunetaly that the pcap just on one server, and there is none on the far-end server.So what happend when the tcp session is more than 1 hour on asa? Does asa send tcp reset flag to both server?
Hello sir, Thank you for your enlighment, if i may add another question, so i just show module in my nexus and find out that my ehternet 3 is 1/10 Gbps Ethernet Module, with the module is https://www.cisco.com/c/en/us/products/collateral/switches/nex...
I see 3 other identitiy with their issued by symantect, verisign, and digicert.When the certified CSR/SSL arrive from my CA, can i just create a new identitiy certificate and install that SSL to my new identity certificate?What i read is that when we...
