Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have requirement here, There is one Site to site vpn between my office and headoffice. HO team accessing one server from our branch, and they are complaining about our internet, they want us to dedicate 2Mbps to that particular server(ip address...
Dear ,
We recently implemented one polycom RealPresence Group 500 (Release - 6.1.1-370109 ). We have an requirement to register this with our cisco call manager (11.5 ). I tried to register as by adding new Third-party Sip Device (Advanced) o...
Hi.. i would like to give access one of my Server remote to my team who will be working outside.
So tried portforwarding in cisco asa 5510 with CLI as below. but unfortunately it is not working. Please correct me what mistake have done ? Please check...
Hi,
We are using Cisco ASA 5510 with 8.4(7).
I would like to configure an site to site vpn.
My side local ip 192.168.2.0/24
Other side has two lan
local 10.1.1.0/24 and 192.168.2.0/24
My requirement is to communicate with 10.1.1.0/24 from my loca...
Hi Guys..
I would like to configure ISP failover in cisco 2901 router. We are using ADSL as primary WAN and one 4G Modem as Backup WAN. 4G Modem is connected to Gig 0/1 port. I tried with NAT Failover with Route-map and ip sla. But it is not workin...
VPN is not required through Backup 4G, we are looking only a internet failover solution (not VPN failover). We are not able to get internet without NAT GigabitEthernet0/0/1 interface and shutdown Dailer interface through 4G modem. May be because of ...
This is not full config, Crypto map is configured on ADSL interface. We are using Site to site vpn service. It is working fine. But How can i remove double NAT as you suggusted ? can you explain. Because ADSL is directly patched and connected in ADSL...
