Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I want to configure "storm-control action trap" in nexus 5596 switch but there is no option "action" after storm-control command like below. is OS support action command ? OS version is version 5.2(1)N1(1). please help, Thanks in Advance.
sw...
Hi,
I have facing issue during new vlan in nexus 5596 switch interface, after adding new vlan's old vlan get deleted or not seen on interface.
>Before adding the new vlan's interface config. is below
interface Ethernet1/25 inherit port-profile...
We have two p2p links in between two branches connected to two different routers at both ends, we want to load balance traffic on this two links from both ends.
Please help. Thanks in advance.
Hii,
We have one branch with bandwidth of 512 Kbps, we want to prioritize traffic like below
First priority - Citrix traffic
Second priority - Mail and all other traffic
Now my question is that " Bandwidth" statement under QOS config is applicable ...
Hi Peter,
thanks for your suggestion..
I got one Bug (CSCvf50699) on cisco site, it might be possible due to which i face this issue.
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvf50699/?referring_site=bugquickviewredir
Hi Joseph, I worked on this since last few months and didn't get success, you always helped me out for my critical issues.... and this time also..... Thanks a ton for this...i executed the command & it's working fine. both the links are utilize now. ...
Hii Joseph, Thanks for the reply
But i have one doubt, is that my configuration correct ? because i want to reserve the bandwidth of 256 Kbps for traffic between IP address range 10.32.131.0/24 and branch LAN ip range.
i have applied policy on other ...
