how to configure storm-control action in cisco nexus 5596 switch

[Dhiraj Jagdale]

Hi,

I want to configure "storm-control action trap" in nexus 5596 switch but there is no option "action" after storm-control command like below. is OS support action command ? OS version is version 5.2(1)N1(1).  please help, Thanks in Advance.

switch(config-if)#
switch(config-if)# storm-control ?
  broadcast  Broadcast address storm control
  multicast  Multicast address storm control
  unicast    Unicast address storm control

[Deepak Kumar · Accepted solution]

Hi,

By default, the NX-OS software takes no corrective action when the traffic exceeds the configured level. However, you can configure an Embedded Event Management (EEM) action to error-disable an interface if the traffic does not subside (drop below the threshold) within a certain time period.

https://www.cisco.com/c/en/us/support/docs/switches/nexus-7000-series-switches/200247-Nexus-7000-Storm-Control-Selecting-appr.html

Regards,

Deepak Kumar