Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have a 3560 in a remote lab.I needed to bring the ROMMON mode.But the switch doesn't accept the break sequence and boots normally.Is there any way to bring this switch to ROMMON mode apart from using the MODE button physically in the lab .Thanks...
Hi I have a test setup as given below VLAN A has an ip address in subnet of 192.168.X.X /24I need to ping the VLAN B interface from VLAN A,which is an interface on the 3560 belonging to VLAN A.For this i introduced a static route on 3560 as:ip route ...
I am using a switch(3560X) and a router 7606 for the given setup.I am doing a simple simulation of attcaching a port (on 7606 router)to the switch and testing it with various speed ,duplex setting.The switch port is in vlan 2 with ip address x.x.x.23...
HiI have a setup like : The R-1 has an NTP server and NTP peer(R-2).On R-1 i did like: ntp sever <ntp-sever ip add> ntp peer <R-2> Loopback0 ntp source loopback0 ntp update-calen...
Thanks guys for all your help.I used a safe route for this time and told someone in the remote lab to follow standard procedure for getting into ROMMON mode.I'll able to use to your method after a week or two when the switch will be free for test.Tha...
Thanks NikBut i think that your reply will hold in case of routers only not switches.The 3560X i am using does not support the config-register command at global config mode.
NTP peers would sync with each other when the peer is on a better Datum level (worst is 16).So if both the switches are on same datum level they will consider themselves as master.Also use the command sh ntp status to look for the time since NTP upda...
HiWhen you are using the 3750X with ipbase,then it can only be used as a Spoke router not as a hub.Since EIGRP stub cannot acts as transit ,it only act as edge.Also the command:eigrp stub summary,the routes will be summarised,which i think is not des...