Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day,
I have a switch cisco ws-3650 -24ps-s which in rommon mode "switch:" I tried to boot packages.cnf but keeps rebooting.
I tried to copy a new IOS version in rommon mode to flash: but I got a message which indicates an error "Read only fi...
Good day everyone!I have a switch 3560v2 with an IOS 12.2(50) SE1.All the lights ON and console error message below:POST: inline power post failed for port 0 up to port 15.Then, the system hanged and all lights (indicator) ON.Could everyone please he...
Hi all!Could you please help me on my cisco switch problem?My switch prompt shown below:switch:switch:switch:switch:switch:switch:How could I restore my switch back to working condition? I have an IOS image but don't know how to restore from this lev...
Hi!What do I need (type of modules and connectors) if I want to connect catalyst 2960 to catalyst 3548 and/or to catalyst 6500? I think GBIC and GIGASTACK are not applicable anymore to 2960.Your reply is very much appreciated.Thanks a lot.Regards.
Good day sir,Could you please tell me on how to do it?By the way I found the cat3k_caa-recovery.bin in the SDA9. Please check attachment.Sir, what do I do now?Thank you for your reply.Regards,Sanny
Thank you sir. I will try this method.But I don't have tftp server. I just used extra putty and tera term to copy a new IOS to flash. Unfornately, got this message "Read only file system." I think I need to change attribute of the flash from read onl...
Good day everyone!How do I copy/backup .dat file (configuration file) and config.txt from this switch3560 with an switch:prompt?Mr. David gives me a link above with the same problem "Inline Power Post Failed. I can bring this switch to switch:prompt ...
