If you have the ability and can plug directly into the MX do you see the same behavior? When doing this if you can remove all other LAN connections and if you have any default routing over a VPN please disable it for the testing. If the issue persist...

You do have the ability as well to configure the RF profile in which you can lower the MAX radio transmit power range or configure minimum bitrate both of which would affect the range of signal and may stop the device from connection attempts to a fa...

So yes in this case you would need to use bridge mode and enable the L2 LAN isolation feature and put in the firewall rules to allow/deny on the Wireless > Firewall page to allow certain traffic such as DHCP/DNS/Gateway access and then deny the rest....

Typically, I would look at the current power output that the problem APs are putting out along with the environment directly to see if there is anything that may be creating interference with the signal for those particular APs. Are you noticing the ...