Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, I currently have a very large bldg where I have a mix of CW9166s and MR42s. To save on a bit of cost I was thinking of just replacing the MR42s with 9176s. I'm thinking it should still be ok to have to have this slightly mixed setup, though...
I just got an email for an order I placed stating that I needed to assign my order to a Smart Account. I logged into my cisco account and was directed to "License Control" (which I've never seen before). Can someone explain to me whats a Smart Accoun...
I posted a question earlier and got the confirmation that you cannot have mixed licensing models under one org. Migrating all our networks over to a subscription model at once would pretty impossible budget wise. Any ideas how I can work around this?...
Hi there, I currently have PDL licensing in my Org. As I refresh each of my networks (on their own timelines), I would like to set them to be subscription based. Is that possible to have a mix of both PDL and Subscription in one organization?Also, do...
How would provide feedback on some issues I've run into with early access features?For SmartPort Automations, I'm running into an issue where the port wont trigger for devices added after the switch is applied to the automation, so I have to remove t...
We've had this issue last school year as well, but we don't allow student printing so it only affected our operations folks who use iPads primiarly. I rolled back firmware on our aps, rebooted, factory reset, and nothing. We ultimately had to install...
That was it! I was running the packet capture on the switchport the camera was connecting to. Once I ran a capture on my first switch outgoing port, all the specific traffic is showing the new DSCP. Thank you for the quick help on this!
