Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,I have a new Cisco 8540 Wireless Controller that I installed last week. I created a test WLAN, forced an AP to join the new controller and it does join plus a laptop shows as joined. Now the issue is that the laptop does not get an IP ...
Good Day Cisco Comminuty,I have a new 8540 WLC, that is joining an old 2504 WLC. The plan is to remove the old and have the new one running alone. Now I would like my AP's to distribute ip addresses from a special pool that I setup on my Windows DHCP...
Hello All, I was given a 8540 WLC sitting on a CIMC server, and I tried so many times to install the primary image, clear configs, manually upload an image with no luck. I even sent Cisco TAC an email and I was told we do not have a support contract ...
Good Day All, Its me again................ I have a brand new Cisco 8500 WLC and on boot up it gets an IP and when I try to logon tot the console via web it wont take Cisco username and Cisco1234 password, please assist. See attached.........
Hi Everyone,
My AP's keep rebooting please help;
*spamApTask5: Feb 19 16:38:29.465: %RRM-3-RRM_LOGMSG: rrmClient.c:777 RRM LOG: Hyperlocation config not supported for this AP
*spamApTask5: Feb 19 16:38:24.149: %RRM-3-RRM_LOGMSG: rrmClient.c:777 R...
Hi Ric,
I installed the supplementary bundle (AIR-CT2500-AP_BUNDLE-K9-8-5-135-0) and it worked, all AP's are up and running.
Thanks a lot.
Am running a 2504 on my site.
