Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiPlease could someone assist me with how to configure SFTP client traffic through an ASA FW to an external server address.I have inherited the issue and its been a while since I performed similar tasks and all commands on the appliance seem to have ...
HiI have been trying to find out the best practice for configuring our Cisco 3750 switches for Avaya softphones.I have been using the "Auto QoS VoIP Cisco-Softphone" command and have configured the port as "Switchport mode access" and not a Trunk, al...
Hi I currently have a WAN link setup consisting of a 1721 router with 1 x WIC1-ADSL and 1 x FastEthernet Int (with static public IP) that is connected to a 1841 router that is configured to establish VPN tunnels to the WAN and provide DHCP to the LAN...
HiCould I have your thoughts on what is the best option as a firewall/VPN appliance. The network I'm looking to deploy the appliance on has a Webserver and a Mail server with Outlook Web access that require outside access. There are a few servers t...
HiI was hoping for some help setting up route-maps on 3750G-12S switches. The 3750's are using 12.2.(35)SE5 IPBase image.I have put in the commands:route-map vlan70 _noproxy permit 10 match ip address 10 set ip default next-hop 10.217.12.1 Then I ha...
Hi GiuseppeThe mask is 29 bit (255.255.255.248) for the public addresses, so 6 hosts, 2 of which are being used, 1 for 1721 and the other for the VPN tunnel on 1841.We would ideally like to add an additional Ethernet port into the 1721 for the Alarm ...
