Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For those that have rolled out Meraki WAP's in high density areas such as stadiums and arena's, what do you typically see your "Network Health Score" drop down to during busy events?
We're seeing an issue on our 9200 series switches where we get the message "Method Status List Empty" when trying to authenticate devices either for the first time, or when a switch is restarted. To resolve, "clear authentication sessions" is require...
I'm currently looking at RADIUS on some of our switches and noticed that the RADIUS type is showing as "non-standard".Server group ManagementSharecount = 1 sg_unconfigured = FALSEType = non-standard Memlocks = 1Server(192.168.1.50:1812,1813) Transact...
Wondering if anyone can help. We have 802.1x setup with authentication using Machine Certificates (EAP-TLS) but coming across an issue when machines are powered off.We have Wake on LAN enabled on our devices so when a device is powered off the NIC is...
We have RADIUS setup on our switches with 2x RADIUS servers used for authenticating admin access to the switch's, and 1x RADIUS server used for port authentication for devices (not ISE).When the RADIUS server for port authentication is lost, I need t...
I can see the request on our RADIUS server and accepts the device and returns as accepted, authenticated, and sends the correct VLAN, but when looking on the switch it fails the auth.
See example port config below, this only affects a chunk of ports at a time and affects both data and voice devices...The below config is also set on a large number of switches and is working fine.IOS: 17.6.3Port Config:interface GigabitEthernet1/0/1...
The switches having the issue are C2960X's running version 15.2(2).E7 (older IOS but unable to upgrade at this time).We're using a third party RADIUS product.RADIUS config is the same as other switches (the non-standard is what I'm unable to remove)....
For our trusted devices we authenticate using the machine cert which then get's the production VLAN assigned to it. Because the device is switched off, this method of auth will fail. Any device that does not auth using cert then get's hit by one of t...
After testing, when I look in the MAC table it shows the Cisco IP phone and PC in both the voice and data VLANs (although both devices get an IP in their respective VLANs and ping/work fine), any ideas?8 0087.64a9.dd3a STATIC Gi1/0/18 9c2d.cd38.4bbb ...
