Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a lab set up having cisco 2821 router configured as MGCP gateway and have installed CCM 4.1(3). All cisco IP Phones are registered with CCM and are able to call from one IP Phone to other. Now I am planning to establish intercluster cal...
Hi All,i am using Cisco 12000 router with 3GE-GBIC-SC module on the same. Since I am unable to do dot1q in dot1q, can any one suggest me if this module support this feature or not?Thanks and RegardsMangesh A. Bhende
Dear All, At presently I am using Catalyst 3750 switch as a layer 3 switch with switch ports as a routed ports with an ip address configured on them. Now when i tried to configure CBWFQ on the switch it was accepting the commands for Class-map, p...
Hi All,While booting Cisco CWWLSE-1130-19-k9 we are getting error saying that GRUB loading, please wait...Error 15. and system reboots. Hence kindly help me to identify what is this error and how can I rectify this problem?Thanks and RegardsMangesh A...
Hi Java/Nickit was my misunderstanding that I need to register MGCP gateway with ccm for doing call routing with other CCM cluster. After your comment I havr created a trunk and then route pattern to route the calls. It was sussussfull. This has solv...
Hi java,Please correct me if i am wrong, For me to route the VOIP calls to other CCM cluster i need to register gateway then form trunk and then route the calls using route pattern. Is that correct?RegardsMangesh A. Bhende
Hi Java,In my setup I dont have any PRI or FXS/FXO interfaces, only have IP Phones with which I am planning to establish intercluster calls.In terms of configuration I have only ip address assignment and pure IP routing is enabled.
Hi Nick,Yes I have added GW-1 correctly in CCM with 2821 MGCP in CCM as well as on 2821 router. if you see the debug mgcp packets the CCM is not sending GW-1 in its mgcp message and i think that is the reason why it is not getting registered. Any ide...
