Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we have a 1240 access point on our speed test we are getting only about 13MB when we should get around 30MB my vendor is telling me thats becuase the radio only works on half duplex is that correct??
Hi,i have 2 cisco aironets 1240 connected on site-1 to a 3750 and site-b to a 3560 switch...i've called TAC a few times to help with setting up an EtherChannel beetween these 2 bridges but they have no clue how to do it...every tech tells me somthing...
Hi,i have 2 cisco aironets connected on site-1 to a 3750 and site-b to a 3560 switch...i've called TAC a few times to help with setting up an EtherChannel beetween these 2 bridges but they have no clue how to do it...every tech tells me somthing else...
thx for the replyis there any cisco doc that show that? i need to show it to my boss!so would it make sense that the speed shows half of what it suppose to be?
can you be a bit more detailed on how to configure it and what will it do.... last time i plugged in both bridges at the same time it took down my network because it created a loop...i dont want this to happen again.
ya im looking for automatic failover and i do have layer 3 switches on both ends and multiple vlans on each side so routing is enabled, i did find Document ID: 71478 on cisco looks like its possible it just dosent give me the steps to actually config...
thx for the replyso what would be the way to configure this my goal is to combine the 2 bridges for speed and have failover at the same time how can i accomplish this task?
