Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Customer is having network topology like this,Customer is having 2 Mbps link from Service provider which is connected to PIX,Customer requirement is how can he alocate bandwidth to 3 Departments using current setup....Note:One Department will requ...
Hai,Was going thru some mpls documents...there was lots of confusion still,....abt ipv4,vpnv4...LDP ..(Types of LDP)...RT and RT value ...its going on ...can some one help me in understanding MPLS right from the basics....any gud link would be helpfu...
Hi,One of my customer is facing strange issue.Total BW of the link is 20 Mbps 1:4,Customer is using full BGP route from service provider.Below is the config customer is having....As per customer BGP itself is taking 6 Mbps .....router bgp 16838 no s...
Hi,ISP-ACC-RTR-XX>show ip cef | in Serial0/1/0.1/1/1/1:0XX.XX.XX.XX/30 attached Serial0/1/0.1/1/1/1:0XX.XX.XX.XX/28 attached Serial0/1/0.1/1/1/1:0Want to know the command in junper router for the abow output..is there any ...
Hi,how can i config nat in router..using "Only WAN" ip.ISP has blocked entire /28 lan ip due to some span issue....for time being thought of using wan ip for NATing ... can some one help me in configuring the same ...would be very much appreciated .....
Hi,Thanks for the reply,Yes its going over fiber,But exchange end there will be an Electrical drop were Master modem will be connected from there its going via "Copper" till customer premises."Means you have fiber till customer premise "No ... if fib...
Hi,We have many customers which is not having MUX at their premises. As per customer requirement our vendor suggested E1 to Ethernet converter...this has tested and implemented successfully.. eg: customer requirement was 8 Mbps (there was no feasibi...
Hi Joseph,Thanks for the detailed explanation.Very informative,But little confused about this term"configure proportional bandwidth sharing"..would be helpfull if you can elabrate some more on this.ujil
