Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am trying to install a SSL certificate on my ASA 5505 prior to configuring the anyconnect client. I tried doing it by following the documentation here:http://cisco.com/en/US/products/ps6120/products_configuration_example09186a00808b3cff.shtm...
Hi, I have an ASA 5505 running 7.2.(4). I have a dmz configured which can access the outside via the implicit rule to permit all traffic to less secure networks. When I try to apply an access-list on the dmz interface to permit https access to a serv...
Hello, I have a very odd problem. When connected to the VPN, I can connect to all my servers without problem on any services. On a single server, when I try to connect to Windows shares, it doesn't work. My event log shows nothing on the client or on...
Hello,I changed the enable password on one of my switches and I can't remember what I picked. I have the snmp write community, is it possible to change the enable password with it through snmp?Thank you
Hello,I followed this guide to setup my vpn using the CLI:http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008060f25c.shtmlMy setup is pretty basic except that I use radius authentication.Right now, I can connect, the au...
Thanks for your answer Eddie, that makes sense. Could you give me an example of an ACE to permit all traffic from the dmz to the outside?Thanks!Etienne
Ok, I found what the problem was. The firewall was set for the local subnet only. My old vpn was giving IPs from the same range...Sometimes you look too far! Thanks for your help.
Hello,I'm running the 7.2(4) software. I can connect to the server using remote desktop but if I do \\192.168.1.9 it says: "No provider has accepted the given network path".I looked at the MTU locally using ping 192.168.1.9 -f -l and only 1272 will w...
Hi Arul, This server is configured the same way the rest are. I can connect to the webserver or remote desktop to it. It is only happening with SMB. That's weird... Can it be a MTU issue?ER
