Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I enabled SIP Inspection on our ASA but when I do a packet capture, I see that the Contact URI Host Part is still showing the internal IP address of the phone server and not the IP address that the phone server is NAT'ed to via a static NAT entry. An...
Hello, I am trying to figure out how to force all traffic from remote vpn users to go through the vpn tunnel for internet access and have run into a road block. Right now, I have split tunneling working for one profile and the other profile is to for...
Hello All, I have a site to site VPN setup (both sites have Cisco ASA's) where my internal network is 192.168.1.0/24 and the other site's internal network happens to have the exact same internal network. Is there a way that I can NAT my internal ...
If I have 10 locations having a single T1 which are PVC's and two locations which are DS3's PVC and at 10Mb. By using Adaptive Frame Relay Traffic Shapping, would I be able to, when congestion is high between the two sites with the 10Mb link, realloc...
I just made the change and no luck. Any thoughts as to where I might look to test? I ran the packet tracer and set it it up with the following:interface - outsidesource ip - vpn pool ip addressdest ip - google.comreverse path failure is the result...
