About kcurry9806

kcurry9806 · 10-29-2008

Is it possible to allow the same mac address to be configured to two different ports? Due to security requirements where I work a typical configuration for a port connecting to an end device (PC) we enable:switchport mode accessswitchport port-securi...

kcurry9806 · 09-10-2008

WS-C2950C-24 IOS V12.1(20)EA1. I am trying to configure the vlan to no ip redirects and no proxy-arp with no success. I have tried configuring these settings under interface w/o success either. Does this IOS version not recognize these settings?

kcurry9806 · 10-29-2008

I tested this process on two WS-C2950T-48-SI switches. One did not work, but on the second I was able to successfully connect the laptop to two different ports. In fact, with switchport port-security maximum 2 set, I was able to connect a second lap...

kcurry9806 · 10-29-2008

1. When I try to add the same mac address to the second port we get the message "Found duplicate mac address." Any attempt to connect the laptop to the second port after the mac is stuck to the first port will error-disable the second port. (We have ...

kcurry9806 · 09-10-2008

Thanks Shaheen. So these settings are available in the IOS version 12.1(22)EA9 and later. Do you know is this documented anywhere on the Cisco website?This is interesting because we just set these variables in a WS-C2962G-24TC-L switch that the CNA i...

kcurry9806 · 09-10-2008

Thank you very much,Ken

Member Since	‎09-10-2008 06:26 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

Catalyst 2950 same mac on two ports

Configuring WS-C2950C-24

Re: Catalyst 2950 same mac on two ports

Re: Catalyst 2950 same mac on two ports

Re: Configuring WS-C2950C-24

Re: Configuring WS-C2950C-24