Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So some of you may have read the prior thread where I was grousing about the MS120s not passing OSPF.https://community.meraki.com/t5/Switching/MS-120-won-t-even-pass-OSPF-traffic-unmolested/m-p/66401#M5228In the process of troubleshooting the MS120s ...
Which Layer 7 category would block privacy VPNs? I need this for my public wireless network SSID. The privacy VPNs circumvent policy that I have in place for blocking certain sites/services. Is it the "Security" category that I see in the list?I c...
I wish Meraki did have a VRF capable switch. I could EOL our Cisco router fleet. As it is, I am thinking of replacing them (ASR/ISR) with some Ruckus switches with advanced IP license which my firewall reseller likes and recommends. We do not tax ...
Exactly Philip, whatever is the next device downstream will need a static route back to any subnets that are not on the same VLAN as the connected VLAN. If you don't give it this, then it's only going to see the VLAN that it is connected to on the M...
This really sounds the same as the MAC flap issue on 11.x.Or the MAC flap issue is the same as this.If it's the MAC flap issue then the STP messages are just a byproduct of the port going down. If this is a separate and distinct issue with the BPDUs...
I have 22 HP MFPs in this building and I have no issues like the one you describe. The printer models are the 67560 and the 87660 Running a mix of MS250s and MS42Ps, the printers would be plugged into one of those two models.One thing I do when I ...
The OP says that they cannot do the "good stuff" with Meraki switches that they could with "normal cisco switches". Well, Meraki leaves out most of the irrelevant stuff too, or is irrelevant for 80-90% of organizations.Meraki was acquired by Cisco i...