About Farhan Mohamed

Farhan Mohamed · 09-18-2020

Installing and Activating Service on the Cisco DNAC Appliance v1.2.8 This document describes the steps that you need to follow to install and activate the Cisco Digital Network Architecture v1.2.8 Note: For additional information about how to use th...

Farhan Mohamed · 07-01-2019

Cisco DNA Center v1.3 will have Rolling Software Updates as other tools in cisco, hence you are not getting the banner. What happens is whenever any new software or updates gets released, it is available for cetain list of customers. This validation ...

Farhan Mohamed · 07-01-2019

As of now DNAC is not supported or cannot be installed in form for ESXi VM or Hyper-V. This is something cisco is planning on later half of this FY. But nothing is official yet, But what i can think of this you can still control or play around in an ...

Farhan Mohamed · 07-01-2019

Ideally if you break the configuration in anyway, where you would need to re-built and start from all over again, then connecting with TAC is ideal thing to do as TAC will get you the iso image from where you can launch back once again. Please take a...

Farhan Mohamed · 06-17-2019

You will need to go into the LSI MegaRaid Controller Bios (Ctrl + H) and select the virtual drives option on the left. When the Virtual Drives window opens, you must select the drive (the Raid Volume) that you want as your primary boot disk and below...

Farhan Mohamed · 06-17-2019

Total VNs or virtuals networks will be one in case of 9200 switch. This information is pulled from Cisco Datasheet.

Member Since	‎04-08-2013 07:14 AM
Date Last Visited	‎07-11-2019 11:34 PM
Posts	179
Total Helpful Votes Received	123

User Statistics

User Activity

Service Activation: Installing and Activating Service on the Cisco DNAC Appliance (version 1.2.8)

Re: Upgrade to 1.3 - No banner

Re: DNA Center virtual

Re: Start the configuration wizard over again

Re: Cisco DNA Pixie Boot

Re: 9200 switch Virtual Network