Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello AllWe upgraded our 9800 WLC firmware Friday 1st March from version 17.3.6 to 17.9.4.We have a variation of Access Point Models across site as shown below:AIR-AP1542D-E-K9C9105AXI-EC9124AXISince this upgrade to 17.9.4 we are having issues with o...
Hi
I have tried to run the # show running-config command on a C2951 but I receive the message % Invalid input detected at '^' marker and no information is output. The command works on other Cisco switches we have in the infrastructure and running t...
Hello AllUpdateWe believe we have managed to solve this now as all scan guns are able to connect to the required wireless SSID via the AIR-AP1542D-E-K9 APs.It seems that during the upgrade the Layer 2 Security for the Scanners SSID was set to WPA2 + ...
As an update we have updated the WLC to 17.9.5 and this has not solved the issue.We have narrowed down the issue to the use of the scan gun SSID with the AIR-AP1542D-E-K9 APs. Other findings:1.) Corporate PC, Corporate Mobile Phone, and Guest Wirele...
Will do.
I'll choose your previous answer as the correct one as it does seem to be a privilege/rights issue that we will need to resolve internally.
Thanks agian.
Hi Georg
I think that may be the case as I failed to mention previously that the c2951 was initially setup by the team on site here but it was configured further by another team and our account may have had its privileges reduced.
Please see image...
