Hi,I am having a problem of connecting to some routers. I have attachted a picture of what I have laid out but I am starting to learn how to do this type of stuff, since I am in college. Any help will be much appreciated.
I am using a simulator that was given to me for practice.I am trying to get the serial ports and the line protocol both up. If they are both up, I will be able to connect to the other devices such as routers and PCs.Here is the information I get.Rout...
What if your device is showing HD with numbers in the end?What type of device shows that it is a DTE or a DCE device?If it does'nt how do you change it?I have been looking at this for about 2 days and I am somewhat still confused.Please post any help...
Hi,I have figured out how to get the ethernet ports working on each router and they are seeing each other. But I am experiencing a problem with the serial ports. Here is what I got as an error message.Serial0 is up, line protocol is down.and I also g...
I tried to setup clocking but the alive time is 10sec and by the time I get into the other right it times out. I have two terminals that are suppose to see each other through 5 routers. I am confused as how to go about connecting this up since my eth...
I know how to do the commands, but my problem lies with the serial ports (s0 and s1). These serial ports go up then go back down. They don't stay up. What am I doing wrong?int s0ip address 126.110.10.5 255.0.0.0no shutMessage shows status is up, then...
