Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I need your suggestion on my following issue:I have configure the ACL entries on my cisco 6500 series box but I see the ACL entries showing incorrect order when I check for the same.Eg:Europebox#show access-list 5010 permit 192.50.20.2 (10 ma...
Hi Experts,I am not able to upload the firmware on the ACE module.Laptop--consolecable---ACE modulerommon >Loading disk0:c6ace-t1k9-mz.A2_1_6.bin. Please wait .... file(disk0:c6ace-t1k9-mz.A2_1_6.bin) open error loadprog: error - on file open boot: ...
Hi,I am not able to save the configuration on the ACE module.Admin# wr memGenerating configuration....Error in generating running config..copy aborted"Write memory failed for context Admin"Any help would be appriated.ThanksNeha
Currently CSM1 is active and CSM2 is standby.All the traffic currently flowing though the CSM1 which is currently Active which is perfectly correct. Now we Need to check the redundancy behaviour by bringing down the CSM1 and make CSM2 as active so th...
Hi Syed,What happens if I increase the priority on CSM 2 will it take over the role of Active? If yes will there be any impact ? Will all the active sessions from CSM1 will be pour down to CSM2????Thanks in advance,.Regards,Neha,.
Hi Syed,I dont want to power off the module. And how can I use the clear module command as I have enabled the prempt on my csm and the pdf documents says dont use it if you are configured prempt command.Any comments from you on this???Regards,Neha
Hi Inayath,Thanks. But why is that only couple of servers with parameters are been hit? If bug is the cause then all the servers with any port number should not have been hit?Thanks in advance.Regards,Neha.
Hi,The appliance is not accessible via the console port. Console port is not responding so Do you recommend to re-image? As I am able to access the ACS via web intrfce and it is processing the request. Only thing is it does not repond on the console ...
