Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI have some doubs about users license on ASA.When i purchase a CSC-SSM-10 or CSC-SSM-20, there are up to 1000 users licensed. What are they users from ????If all my users are located behind a proxy, what user (proxy ip) or users (all users) are...
Hi allI have some doubs about users license on ASA.When i purchase a CSC-SSM-10 or CSC-SSM-20, there are up to 1000 users licensed. What are they users from ????If all my users are located behind a proxy, what user (proxy ip) or users (all users) are...
Hi allI have 2 vpn3030 in VRRP and load balancing.I stablish the connection to Virtual IP, and I see the connex go throug one of them. If I shutdown the master, all vpns connections go to the other one.This is a normal behaviour.BUT, What happens if ...
Hi allI have 2 vpn3030 in VRRP and load balancing.I stablish the connection to Virtual IP, and I see the connex go throug one of them. If I shutdown the master, all vpns connections go to the other one.This is a normal behaviour.BUT, What happens if ...
I have a pix running 7.0.2 and multicast routing.When I configure only one RP, all things go fine. Indeed, all suscribers see the mroutes as well as pix.So, if I configure several rp for several multicast group, nothing is working. Pix can not see an...
I would debug AAA and I would try to guess what is the problem and differences beetwen IOS versions.At last, I would upgrade IOS from one AAA failure 3700 to same version Router 3790 is working fine. If this upgrade is working fine .... is up to you....
There is usually one user configured inside the platform for backway access to the PIXI mean, you are recommended to configure an user account into the pix, i say locally to grant access to the PIX in case AAA failure (PIX can contact AAA Server or A...
Hi you can fix as many routes as you want, but you must be carefully with metricsYou also must be very, very carefull with access-list and nat statements, because the default route flap, you need to apply different filters on different interfaces.Reg...
It is a command you can use in any platform and any version.Here you have the link you requested.http://www.cisco.com/en/US/partner/products/sw/secursw/ps2120/prod_release_note09186a00801a6d21.htmlI put the output for PIX 525UR.RegardsRoberto
Hi MacardellYou can see the maximum number of interfaces with the command "Show ver"This command returns as following:...... (omited output).......Maximum Physical Interfaces:3 Maximum Interfaces: 5 ........The Maximum Physical Interfaces is ...
