Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all!I tried to deploy a network infrastucture with 6 switches (different vendors).The Problem seems to be, that I have 2 root bridges. Ok I think one switch dont forward the BPDU, so two trees are established.SW01 --- SW03 --- SW05 --- SW06
| ...
Hi all!I have a well working site2site tunnel.Net 1 <====> Net2Now, I need to restrict access from Net2 to Net1 but full access for Net1 to Net2.I have a ACE in the outside chain, which deny access from net2 to net1I tried several ohter combination ...
Hi all!The Problem is, that in a remote location is a FAX-SIP-Adapter with his factory default address 192.168.2.1. I need to configure this device.In the remote network has the address range 192.168.170.0/24.Well, I tried to change the intern interf...
Hi all!I'd like to use a Catalyst 3500 for VoIP traffic.Can I use the QoS feature without any configuration? Just sending ethernet frames with priority?Deployment:Catalyst -> Phone -> PCThe Phone have a single VLAN und the PC should be in the nativ V...
Hi all,what is the purpose of the "Permint all traffic to less secure networks".Well I know the purpose and the technique to handle some sercurity level is nice. But what kind of help is it, when I cannot add add a rule without deleting this implicit...
Hi,It's impossible, you can only have one root bridge per VLAN( PVST+,RPVST+) or for multiple VLANs( MST).right! OK, it seems that SW05 and SW03 don't speak to each other.But I can ping in the entire network.SW05 is a Brocade FLS648 and SW05 is a In...
PIX# sh access-listaccess-list cached ACL log flows: total 0, denied 0 (deny-flow-max 256) alert-interval 300access-list WEB; 2 elementsaccess-list WEB line 1 permit tcp any any (hitcnt=23)access-list WEB line 2 permit udp any any (hitcnt=...
