Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Could someone explain me this:
CSW-1#conf tEnter configuration commands, one per line. End with CNTL/Z.CSW-1(config)#do sh vtp statusVTP Version capable : 1 to 3VTP version running : 1VTP Domain Name :VTP Pruning Mode : DisabledVTP Traps Generation ...
I would like to use the archive feature to backup configurations when someone does a write mem. This can be easily done, however not with a passwordless setup. This means I would like to generate a pub+priv. key and export the pub. key to the SCP hos...
Hi All,I have my hub (HQ) and spoke (RO) network. My RO has several WAN links which are extremely unreliable. I get an IP-address via DHCP on those interfaces and I'm behind a NAT.However I would like to monitor the devices in my RO so DMVPN would be...
They are both version 3:
DSW-1>sh vtp statusVTP Version capable : 1 to 3VTP version running : 3VTP Domain Name : SiteAVTP Pruning Mode : DisabledVTP Traps Generation : DisabledDevice ID : 0088.1b6a.ac00
Feature VLAN:--------------VTP Operating Mode :...
I did some research and if i'm corrent there are three ways to solve this issue;1: Multiple tunnels (one for each uplink).2: Interface state tracking3: Something with vrf or nhrpIf someone could push me in the right direction It would be much appreci...
