Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I feel lack of freedom in selection of IPv6 IOS: as per my experience we start with SRC, then we upgarde to SRC3, then to SRD, now we are running SRD4 on our Cisco7600 with SUP32 and Cisco7600 with RSP720, these all upgrades are because of some BUG ...
I have implementated IPv6-Only LAN (wired and Wireless) at our office, and enable the it to browse IPv6 and IPv4 web sites at sametime without any involvement host machine. This is done by DNS64 and NAT64. Implemenation details and configuration ar...
you have to give "isis three-way-handshake ietf" command on interface to have 15byte TLV Point-to-point Adjacency State (t=240, l=15) Type: 240 Length: 15 Adjacency State: Up (0) Extended Local circuit ID: 0x00000100 Neighbor SystemID: 010...
hi, There is slight Difference between NAT-PT and NAT64, NAT64 is ment for to make IPv6 operate in IPv4 dominate Internet .... where NAT-PT is the technique is IPv4 operate in IPv6 dominate Word... Following line of code of Cisco Device will help...
According to my knowledge....there are two(2) commercial solution available .... one by Cisco (CGv6 blade for CRS-1 ) and other by Microsoft (Forefront UAG Direct Access).Additionally, NAT64 is not simple NAT-PT, where it has variation, by which it e...
