Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to see if there are ports on a SG500 switch are not used for some time.The option show interface | last input does not work/not availablethe show interfaces does not show the information I want.
We have a WLC 2504 with several 27021-E-K9 AP's that are working fine. We now have 2 2702i-UX-K9 AP's and I was able to Prime the AP's with the mobile app. I pressed configure (only option) and than the AP's auto reset and the AP's are not connection...
cleared private-config
reload AP
WLC was able to see the AP again.
Set the AP to local
Created a SSID unprime with WPA key
Connect my mobiel started the app and I was able to configure
After reload of the AP the WLC was silll seeing the AP and then I...
For now I cleared the private-config.
Ik can see the AP again in the WLC but now it is unprimed.
Configured the AP now as I want it to work. Tomorrow I go on site and will prime the AP again. Ik hope this is the solution.
I found in de WLC log the problem and after search the net I found the following:
https://community.cisco.com/t5/wireless-and-mobility/ap-not-joining-wlc-regulatory-domain-problems/td-p/3217274
Seems that I am in the same boat as Sergej with bug id C...
Thanks for your reply.Should have told that earlier, but time and date are right. I already checked this. I checked lots of things but cannot find the problem.
