Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,We have a 3 switches stack (Cat. 9200) running IOS XE 17.6.5 with the CPU overloaded with SISF Switcher Th process :PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process433 1401525420 72375221 19364 79.83% 81.16% 82.11% 0 SISF Sw...
Hi guys, I use Cisco Prime Infrastructure to manage devices. I would like to update Cat. 2960X with release 15.2.7E4. For security purpose the devices are managed over a dedicated IP address (It can either be a SVI in case there are several swtiches ...
Hi, I have a strange behavior on a Catalyst 9200 (Running IOS-XE 16.12.4). In the log the following recurrent set of message prints out :Feb 24 07:43:35.611: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/5: PD removedFeb 24 07:43:36.602: %ILPOWER-5-DET...
Hi guys,I'm running Smart Software Manager On-Prem release 8-202304 and I'm still having the same issue. Did any of you eventually manage to get it fixed ?Kind regards, Vincent
Yes we have 2 SNMP supervision on-going (we're under a supervision migration process, so legacy and new supervision system polls the device), but we do not have DNA center in our infrastructure.
Hi,Eventually I upgraded to 17.9.3 but the behavior remains the same. I was able to run the command suggested by Leo on another equipment where DHCP snooping is not yet disabled. Here is the result.chun-hdie-sr54-dsw1#show platform software status co...
Hi guys,Thanks for suggestion. Since there is already a CPU overload I will 1st try to upgrade to release 17.9.3 then I'll see how to move forward.Vincent
Hi Leo,As mentionned, as I disabled the DHCP snooping, there is no more CPU overload. However this is a workaround that cannot remain on the long term.Regards, Vincent
