Hello,
I have a Cisco 2960X stacked switch.
I've configured central login via our TACACS+ service, which works without issue.
But I've come across, that I can't log in via the console cable to the switch.
I've tried several setting for the AAA Au...
Hello,
I sadly have an issue I hope you can assist me with:
Scenario:
User connect with split-tunnel to ASA5505. Client needs to access network that the ASA has a S2S VPN too.
The split-tunnel allows the subnet. The S2S VPN encryption matches the t...
I've found the issue.
On the Cisco router, there was an NAT ACL.I had to put in a deny IP 10.50.56.0 0.0.0.255 10.255.255.0 0.0.0.255
Else the traffic would be NAT'et to another interface IP.
Thank you very much for the assistance in the troubles...
Hi Rahul,
I've added the new NAT-rule as requested:
This is the out-put from the show crypto:
Crypto map tag: outside_map1, seq num: 3, local addr: 116.246.2.126
access-list outside_cryptomap extended permit ip 10.255.255.0 255.255.255.0 10.50.56...
Hello Rahul,
Thank you for your response.
The Enable "same-security-traffic permit intra-interface" have I already set
The nat (any,any) source static RFC1819 RFC1819 destination static RFC1819 RFC1819 no-proxy-arp route lookup" syntax is not pos...