Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to get a spare Sup. V engine module operational in a 4507E and get the above message when it try to boots. I am not aware if this spare had been used in production before. Not sure if I need to open a support ticket, so I thought I would s...
We purchased an 3925 with a 16 port Gig SM module installed.When I boot up router, those interfaces do not show up. Do I have to do anything special to enable those interfaces to be seen on router.(The 4th Gig interface show up as GI1/0, but I don't ...
We just purchased a refurbished Pix 535 with ver 7.2(4) as a temp. solution until a backorderd ASA5550 arrives.The Pix 535 will replace our existing Pix 525, which has ver 6.3(4).I've read through some of the config. coversion documention concerning ...
We upgraded our internet connection to 300Mb today utilizing a pix-1ge-66 card.The connection used to be 100mb via the standard 100Mb port that ships with unit.Since that time, access to "some" of our internal sites stopped.We own a Class B address s...
Our Pix 525 gig port just went belly up.While awaiting spare part, I connected our Internet connection directly to a 3750e gig port instead of the PIX.Everything works great.I then want to apply the same ACL I used on the firewall to the 3750e's por...
Thanks Jon.I haven't work on a firewall in a couple of years, so I wanted to make sure the migration went smoothly.I always get confused around the NAT syntax.Again, I appreciate your quick response.Thanks,Tom
Thanks Federico.I apologize for late response, but I went on vacation after posting this message.We have an ASA5550 on order, so we are going to table any further troubleshooting on the PIX.Thanks again.Tom
