Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I'm facing a challenge regarding mounting of the AIR-AP1572EAC-E-K9 onto a light pole with a diameter of 52cm. According to the ordering guide, the AIR-ACCPMK1570-2= Wall or pole (2 to 16 inches in diameter) with tilt adjustmentsupports up ...
Hi all, Within GNS3 I have succesfully created a DMVPN phase 3 topology with 1 HUB and 2 Spokes and all works well.I'm building a DMVPN topology with "real routers" but I get stuck.On the spoke there is no output with the "sh ip nhrp" command.At leas...
Hi all, I've read a lot of discussions about Hairpin NAT for Cisco IOS router. Mostly about creating an NVI, PBR or split DNS.On my Mikrotik home router I was facing this issue as well but it was easy to enable a Hairpin NAT solution, seehttps://wiki...
Hey guys,
We have a test lab in our office where we used to work with a Cisco 887va on a VDSL circuit.
Now we have a new setup with a Cisco ISRC1117-4PLTEEA on the same circuit.
The latter is using IOS-XE.
Everything works fine except for the vo...
Hi all,
We have a lot of setups with Cisco 887va VDSL separated by a data EVC and Voice EVC. This is tagged traffic and thus created 2 subinterfaces on ethernet 0. These connect to dialer1 and dialer2 respectively. Most networks are relatively simp...
hello Georg,Tnx for your reply. I've added the command, but still no joy.here's the HUB config: interface Tunnel0
description DMVPN-HUB
ip address 10.0.1.1 255.255.255.0
no ip redirects
ip mtu 1400
no ip next-hop-self eigrp 90
ip nhrp authentic...
Hello Paul, Thanks for your reply. Ok, so it's not possible like the way I provided in post? I read that NVI puts strain on the cpu, it's a 887 series router. Is NVI still the recommended method in this case?
thank you Georg, much appreciated.
I tried to adjust, but gave me this: fair-queue not allowed in a parent policy
About the bandwith
I see the priority % is based on the shaped average in parent policy so that's fine indeed.
Thanks.
Hello,
This is an example of a customer who is using voice on the data vlan, so I need to match on dialer 1 which is the internet evc.
The upload cir is 2mbit.
---------------------
class-map match-any VOICEmatch protocol rtp audio match dscp ef ...
