Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I’m new user on Cisco system and I need help.
I would like to extend my wifi network with an CAP 2602I-E-K9
My wireless network is generated from my « internet box ». The SSID is « motogp » and the security is WPA/WPA2 mixed. I have 2 channels...
Thanks a lot !!My AP reborn I have just this message but its not important I think Unable to locate IOS image with name **xx**.Boot CMD: 'boot flash:/ap3g2-k9w7-mx.153-3.JF5/ap3g2-k9w7-xx.153-3.JF5'Loading "flash:/ap3g2-k9w7-mx.153-3.JF5/ap3g2-k9w7...
Hello and Thank you for help.
I'm trying to use this https://mrncciew.com/2013/12/13/ap-conversion-using-mode-button/ because other it's not possible. I don't have IP on AP...
When I depressed 23 secondes the mode button the ip of the AP is 10.0.0.1 ...
Hello, not now because : I have many problems with my cap2602i-e-k9.I performed an update but I did a mistake. I downloaded a lightness mode or an I need an autonomous mode.So I download the good image ap3g2-k9w7-tar.153-3.JF5.tar and I renamed ap3g2...
So I'm surprise because many users said "it's not possible to connect the Cisco device with a non Cisco device" ...
I tried to remove the security but it's the same result...
Do you think I'm in a wrong way or is not possible ?
Thx