So we've got a new 2960X, model WS-C2960X-48FPD-L. It powers VoIP phones just fine, but none of my APs are coming up. I've tried both 2702e and 2602i WAPs, and neither power on. There's not even a blip on the interface. The stupid thing provides ...
Well...you're on a Cisco forum, so we'd be remiss in not recommending Cisco gear. The Nexus 5548UP is around 17k for the base model without any special layer 3 licenses. http://www.softchoice.com/catalog/en-us/hubs-switches-cisco-nexus-5548up-swit...
Make your config change again, then look to the top right corner of your browser window. You should see a little red symbol. Click on that symbol to save your config to flash, then reboot and see if it works. Working better?
Ahhh, there's the problem.You actually have to change the IP addres of your computer. Look at these steps here:http://www.ehow.com/how_2091900_change-mac-ip-address.htmlOnce you change your IP address (go ahead and match the settings I posted), you...
What did you set your private IP, subnet and gateway as?On my PC, I had to set the private IP (mine was 192.168.1.5), subnet (255.255.255.0) and gateway (192.168.1.254) in order to access it. Also, it looks like it takes about five minutes after th...