Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
On a 6800IA Fex hanging off a 6880-X I am not able to remove the "switchport trunk allowed vlan 1" statement from a switchport I have set to mode access. Yes I have tried "no switchport trunk allowed" on the port config.
interface GigabitEt...
I have a couple routers that when I am on the CLI and start typing the last character is not echoed back to me.
For exmple when I type in:
show run
what I see is:
show ru_
if I hit enter it gives me the show run. Doesn't matter if I use Putty or Sec...
Not sure why it's so prolific now, but more than a few companies have reached out to me because their WAPs are being contained by nearby neighbors via MAC spoofing. Anyone have a preferred way to hunt this kind of thing down? I know Fluke has one o...
I am not having luck adding a newer 2960-X to and existing 2960-S stack
Only 3 switches here.
Existing stack:
WS-C2960S-48TS-L - Switch priority 14 (c2960s-universalk9-mz.152-2.E4.bin)
WS-C2960S-48TS-L - Switch priority 12 (c2960s-universalk9-mz.15...
Hi all,I have installed dozens of WLCs but with this one customer rollout I have hit an impasse. The customer has a 98% MacOS device environment running a 5508 HA pair and 3702i APs. The Mac OSx users randomly lose access even when their device sit...
Oh I hadn't thought about that. However that didn't work either thanks Leo.
s-core01.curtner#sh run int g110/1/0/40Building configuration...Current configuration : 168 bytes!interface GigabitEthernet110/1/0/40 switchport switchport trunk allowed vl...
