Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a client with two seperate Internet connections back to AT&T; one Internet only the other Internet and voice. Each connection terminates to a seperate router with seperate WAN and LAN IP ranges. The two Internet routers currently connect to ...
I have a client with a site-to-site VPN between a 2811 w/security software and an ASA 5505. The VPN was configured about 1 year and has been working no problem. About a week or 2 ago, the VPN will drop after 20 minutes wether traffic is on the VPN ...
We have a client migrating their workstations to Vista from XP, replacing XP workstations with new workstations running Vista, clena install not upgrade. After several workstations were upgraded to Vista, they are not able to get DHCP IP addresses w...
We have a client that is finding a need to limit the users at a remote location from pulling too much bandwidth across their WAN link. The remote site has about 120 users, all DHCP. They want to be able to limit a user from using more than, for exm...
We have a client with a 3825 router with an NM-4T. They are using port 0,1,2 in a ppp multilink bundle. They having slow bandwidth issues and the all of the ports on the NM-4T are showing carrier transitions, even port 3 which does not have anythin...
The Internet routers are managed by AT&T, and I do not have access to them. I am limited to only manipulating the LAN IP ranges.The PIX is doing NAT from the 172.16.1x range to the Internal 192.168.100.x.
The following is a copy of the config.They are also getting the following message on the switch:IP-3-UDP_BADCKSUM: UDP bad checksum The search results on this message do not tell much.I can try and have them set the port host command and see if that ...
The ports on the 2948 have portfast enabled. They used the same switch with the XP workstations without a problem. The client has an old 2924XL switch that is uplink to the 2948G, and the Vista users were able to connect to the network ok after the...
They want to limit general network traffic for the users, not just a specific type of traffic. They had a user from one office login at another office and filled the WAN link while his profile transfered. Also the WAN link is a PPP Multilink with 2...
