Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good afternoon,
We are planning to move a FMC pair which are hosted across two datacentres, to two new datacentres. We have to change the IP address of the FMCs which manage a number of FTD pairs. My plan is:
From the primary FMC (FMC1) GUI go to S...
FMC version - Version 7.2.2 (build 54)
FTD version - 7.0.4
I currently have an Access-Control policy 'DC-Inbound-FTD-AC' which has a list of Mandatory entries at the top to block Bad Networks, Custom URLs and Blocked URLs (based on URL categories) wi...
Hi all,
Scenario:
MPLS Provider -----> WAN Router -----> Cloud Switch ------>Cloud Env.
Our MPLS provider provides us with specific RFC1918 and a default routes via BGP which are learnt via a WAN Router. On the WAN Router, we aggregate the 10....
Afternoon guys,I have the following scenario. I have a c4500 and a c6500 running HSRP:C6500:interface Vlan53 ip address 10.4.35.36 255.255.255.248 standby 53 ip 10.4.35.33 standby 53 priority 105 standby 53 preemptrouter eigrp 10 passive-interfac...
Hello, I have a couple of queries in regards to the DHCP service on Cisco routers. 1 - If you have a DHCP pool configured on a router and also a ip-helper address pointing to DHCP server, what would the router do with a DHCP request? Would it use it...
Thank you ! This makes sense and is way simpler than what I had planned. I have never deployed a FMC or FTD in a live environment, I usually just manage them once they are in service. Looking forward to the migration, good learning curve.
Thank you...
Thank you for your reply.
I never thought about the sftunnel establishment with the secondary FMC, i.e. this information is passed to the FTDs once they have registered with the primary FTD.
Therefore, changing the FTD2's IP address (and physically m...
You have just made my weekend. Thank you!
Following the guide in the link you provided, I was able to simulate a packet and then see the CLI output matching the correct ACL entry!I'll read more about this later.
Thank you again !
