Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I did a cdp neighbors and it is showing me 3 different equipment in the same interface
MAPCO-MDF-SW05#sh cdp ne gi2/0/39 det-------------------------Device ID: SW1Entry address(es): IP address: 10.130.4.1Platform: cisco WS-C3850-24T, Capabilities...
I trying to connect a Fiber using a Media converter so the connectivity its like this
Switch (Fiber) ---- (Fiber)Media Converter(Copper) --- (Copper)Switch
I have activity in the Fiber side of the media converter but not in the switch (Fiber).
...
I will setup two Netowrks in the same organization and thinking of doing the LAN config as follows:MX1LAN Segment 10.175.255.136/29MX IP 10.175.255.138MX2LA Segment 10.175.255.136/29MX IP 10.175.255.139Am I right?
Sure here you go:
GigabitEthernet1/0/5 is down, line protocol is down (notconnect) Hardware is Gigabit Ethernet, address is 7001.b5c4.3085 (bia 7001.b5c4.3085) Description: MOXA_Switch MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec, reliab...
Hi PhilipDAthLet me try to explain myself again.Currently MX1 is up and running it has IP segment 10.175.255.136/29 and the LAN IP address 10.175.255.138 interface 1 and 2 are connected to my CORE Switch connected to interface VLAN 2102, here is the ...
Hi Adam, what I’m trying to do is to connect the MX2 to my CORECurrently MX1 is connected to the Core with the values I showed in my post.My Core switch has an Interface VLAN with IP Address 10.175.255.136/29 and two ports of the MX1 are connected to...
