Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ExpertPlease help...I have two 6509 switches with identical hardware and IOS version. They both are running constantly 89% of memory utilization. However the CPU utilization are quite low.Any idea what caused that, probably the IOS???Thank Kelvin ...
Dear AllI followed the instruction from the Document "Cisco Branch Router Series (NME-NAM) Installation and Configuration Note, 4.2" and the URL is "http://www.cisco.com/en/US/docs/net_mgmt/network_analysis_module_software/4.2/branch_router/configura...
I added a node on the CiscoWork via 'the Common Services". CiscoWork prompted the node was added success.Later, I searched the node in the “Common Services” and could not find it. Then I added the node again. CiscoWork prompted there was a duplicated...
Hi All My CiscoWork discovered duplicated nodes. For examples, a router has 3 physical interfaces and each of it has an IP address.On the CiscoWork device list, I will see three nodes. How can I fix this problem? Please help Regards Kelvin Cheun...
I upgraded the IOS to "s72033-ipservicesk9_wan-mz.122-33.SXH2.bin". The issues did not occur again.Thanks for those who offered help........................Kelvin Cheung
Hi RickySorry for the late reply....The IOS does NOT have the commands you mentioned.Please see the following command output, I hope it helps:cumbdck54rs01#cumbdck54rs01#show memory detailed all dead totals System Memory: 524288K total, 474988K used...
Dear SomuThank for your help.....I think there is no such command "'show memory statistics'" and 'show proc mem sorted' in that IOS version.Pls see the "show command" below, I hope it helps.....cumbdck54rs01#show processes memSystem Memory : 524288K ...
Dear Calin I have about 63GB free disk space. I assumed the application image would be downloaded to the hard disk, But it seemed not the case. Thanks Kelvin Cheung
