trying to recover an admin password for a 31108TCV but its not workingso i press ctrl+c and then it says press ctrl+l to go into recovery mode so i do then i do the commands below  cmdline recoverymode=1 dir boot n3000-uk9-kickstart.6.0.2.U6.8.bin co...

hi all,how do you reset the above switch as theres no physical reset button, so i imagine its all done via command lineis it this write erase reload System configuration has been modified. Save? [yes/no]: n Proceed with reload? [confirm]y delete f...

hi all,got a nexus N3K-C31108TCV and when i connect a console cable to it i get a "loader" linethe switch is also noiser than the rest and its blinking SBS/SRS and the management NIC is always on (nothing plugged into it)do i have to start again, how...

hi all,going to be daisy chaining switches together, we got these QSFP moduleshttps://www.fs.com/uk/products/36157.htmlso we need female to female MPO leads (as the module is male), just dont know if we need polarity A or B or key up or key downthank...

hi all,before on this switch (nexus 7000) i could do a "wr" or "copy run start" no problem but now i get thiswr[########################################] 100%Configuration update aborted: request was abortedthanks,rob