About Sdiana

Sdiana · 01-13-2019

Hi, I am getting the below output on my VSS active switch(4500x-24ES) with IOS version 03.09.00.E RELEASE SOFTWARE (fc1). Could it be the same bug? Executing the command on VSS member switch role = VSS Active, id = 1 Switch mode : Virtual SwitchVirt...

Sdiana · 10-24-2023

Hi Guys, I have faced the similar issue. Can you please share if you manage to resolve the issue.

Sdiana · 05-04-2022

Hi Sajid, Did you managed to resolve the issue? I have the same issue and have added two aaa commands but still Telemetry failed and can't see anything in the output of telemetry commands.

Sdiana · 04-07-2022

Hi Sam, I have a 9800 WLC with IOS Version 16.12.5 and it doesn't recognized this command. Which version have you tried on this command?

Sdiana · 03-07-2022

Hi Elena,How did you manage to factory reset the cEdge router? I want to wipe out the cEdge ISR 4451 config.

Sdiana · 03-02-2022

Hi Arshad, I am not quite sure about the IP which I should use when I configure primary/backup WLC? Is it the service port Management IP or WAP management IP? these IPs 172.16.0.250 & 172.16.0.251? WLC1 (172.16.0.250) = Primary BACKUP (172.16.0.251)...

Member Since	‎01-03-2019 03:23 AM
Date Last Visited	‎11-02-2023 02:46 AM
Posts	15
Total Helpful Votes Received	15

User Statistics

User Activity

CSCud74480 - TACACS cmd authorization fails CLIs spanning VSS-Active and VSS-stby - 1

Re: C9800 not broadcasting SSID's

Re: Cisco 9800 controller discover in cisco prime 3.7 version but not

Re: Master controller mode in 9800 WLC ?

Re: Cisco cEdge ISR4331 Factory reset

Re: WLC 9800 HA N+1 - AP not falling back to primary WLC